PIC16F777-E/ML【PDF 85/231 页】IC PIC MCU FLASH 8KX14 44QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3873

81页 82页 83页 84页 [85页]86页 87页 88页 89页

2009 Microchip Technology Inc.

DS39636D-page 181

PIC18F2X1X/4X1X

16.4.8

I2C MASTER MODE START

CONDITION TIMING

To initiate a Start condition, the user sets the Start

Enable bit, SEN (SSPCON2<0>). If the SDA and SCL

pins are sampled high, the Baud Rate Generator is

reloaded with the contents of SSPADD<6:0> and starts

its count. If SCL and SDA are both sampled high when

the Baud Rate Generator times out (TBRG), the SDA

pin is driven low. The action of the SDA being driven

low while SCL is high is the Start condition and causes

the S bit (SSPSTAT<3>) to be set. Following this, the

Baud Rate Generator is reloaded with the contents of

SSPADD<6:0> and resumes its count. When the Baud

Rate Generator times out (TBRG), the SEN bit

(SSPCON2<0>) will be automatically cleared by

hardware; the Baud Rate Generator is suspended,

leaving the SDA line held low and the Start condition is

complete.

16.4.8.1

WCOL Status Flag

If the user writes the SSPBUF when a Start sequence

is in progress, the WCOL is set and the contents of the

buffer are unchanged (the write doesn’t occur).

FIGURE 16-19:

FIRST START BIT TIMING

Note:

If at the beginning of the Start condition,

the SDA and SCL pins are already sam-

pled low, or if during the Start condition, the

SCL line is sampled low before the SDA

line is driven low, a bus collision occurs,

the Bus Collision Interrupt Flag, BCLIF, is

set, the Start condition is aborted and the

I2C module is reset into its Idle state.

Note:

Because queueing of events is not

allowed, writing to the lower 5 bits of

SSPCON2 is disabled until the Start

condition is complete.

SDA

SCL

TBRG

1st bit

2nd bit

TBRG

SDA = 1,

At completion of Start bit,

SCL = 1

Write to SSPBUF occurs here

TBRG

hardware clears SEN bit

TBRG

Write to SEN bit occurs here

Set S bit (SSPSTAT<3>)

and sets SSPIF bit

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式